+86 576 84407662 sales@xsplasticmould.com

plastic pail mould,plastic bucket mould,pail drum mould by XS MOULD

Plastic pail mould,plastic bucket mould,pail drum mould by XS Mould

In our daily life,lots of plastic household utensils are made by plastic injection molding,such as plastic pail drums,plastic basins,etc.Even though plastic pail mould structure is not complex,but if want to make a nice plastic pail mould,it is not a easy job.We can say if the first time you make plastic pail mould,you will face many troubles.Pail mould decentraction,pail mould wall thickness uneven factores are the usual problems.

How to make sure pail mould concentricity

The wall thickness is even or not  there is a reason causing wall thickness uneven is working on the parting line by hand.Besides,other reasons,like non-proper plastic pail mould design or bad polish work on the core and cavity.So at the beginning,when we design plastic pail mould,we should consider these factores. Sometimes we may make little thick on some areas to enhance pail strength,but we need to think that unven wall thickness will cause uneven injection and unequal cooling.Thus it will slow down injection molding speed,cause sink mark.

Cooling system is also main course for plastic pail mould. We need to design as much cooling lines as possible and proper layout. To get good cooling performance,Becu insert is a good way to improve pail mould cooling.

Written by Cindy Ouyang from XS Plastic Mould Co.,Ltd–Experienced in manufacturing plastic pail drum mould

plastic pail mould

plastic pail mould,plastic bucket mould,pail drum mould by XS MOULD

plastic pail mould

plastic pail mould,plastic bucket mould,pail drum mould by XS MOULD

plastic pail mould

plastic pail mould,plastic bucket mould,pail drum mould by XS MOULD

Leave a reply

Your email address will not be published. Required fields are marked *

Scroll to Top